3D florals for Canvas Corp Brands - 'How To' 3D flowers

Hello folks, one of my creations for Canvas Corp Brands has been published on their blog. So I thought I would share with you a detailed 'how to'.

Here is my 3D floral card I made with Canvas Corp Brands products...

First, I made the 3D flowers from a PaperArtsy Stamp.

Using the Paperartsy Hot Pick Xtra 02 (Flowers) and corresponding dies, I stamped the flower stamps on to a 12 x 12 sheet of 7gypsies Architextures - Travel Habit cardstock and did the same on a piece of 12 x 12 CCB heavy kraft card.

I stamped 2 large flowers and 2 medium sized flowers then die cut them.

The 1st large flower cut a slit from the edge to the centre in between two petals.

The 2nd large flower - cut out one of the petals, then the centre of the flower.

The 1st medium flower - cut out one of the petals, then the centre of the flower.

The 2nd medium flower - cut out two of the petals, and the centre of the flower.

Use the two petals and the one petal from the cut medium flowers.

Glue one cut edge to the other cut edge of each flower with strong glue.

Take the biggest flower and put a big blob of glue in to the centre.

Place the next biggest flower in to the glue. 

Continue with the next biggest flower...

And the next, until all the pieces are placed inside to create the full flower.

Wait for the flowers to dry.

Smaller or bigger flowers can be created using different selections of the stamps.

Using a piece of white card, colour it with Tattered Angels Colour Wash Paint - Weathered Copper and Tattered Angels Glimmer Mist - Pearl and Merlot Gold.

Cut strips of card for the 7gypsies Architextures 12 x 12 - Market Signs and place down the edge of the card.

Using a Canvas Corp small kraft tag, spray with Tattered Angels Glimmer Mist - Tattered Leather. Cut the tag in half and use Canvas Corp hemp rope to the top half of the tag. Put the top half of the tag in the top right corner. Place the bottom half of the tag at the bottom of the card. 

Place a piece of 7gypsies lace trimmings in the bottom left corner.

Place three 3D flowers on to the card. Cut a section of 7gypsies Architextures Tall Base - Triangle Grid to the right, under the flowers.

Stamp the words 'for you' on to a piece of the 7gypsies Architextures - Travel Habit cardstock, which was used for the 3D flowers, using The Artistic Stamper Decay Alphabet stamp set.

Here is the link on the Canvas Corp Brands Blog

Thanks for popping by,

toodles for now.

Lisa xxx 

Here are all the products I used...